Insulation drying units VE Series

Có: 0 sản phẩm trong giỏ

Insulation drying units VE Series
  • Mã SP: SBQTT-VE
  • Giá NY: Liên hệ
  • Giá bán: Liên hệ
  • Tình trạng:
  • Khuyến mãi:
  • Lượt xem: 4185
  • Suitable for overpressure and underpressure operation
    Recessed control panel for extra protection of the control elements
    Dual counter for operational hours and energy consumption
    System units for combined operation
    with Trotec filter chain
    (water separator, microfilters, HEPA filters)
    Auto off function in case of faults
    in the drying chain
    Snap-shut service clamps (VE 4)
    TTSL interface (optional)
    Power Remote Control (PRC) with TTSL VE*: switches the installation on/off via remote control from your office or via your mobile phone
    Stackable to save storage space
  • Tags: Bàn Map
Đơn vị tiền tệ
  • Số lượng:
  • Thành tiền

VE insulation drying units

Technical dataVE 4 MultiQubeVE 6
Article no. 1.560.000.023 1.560.000.030
Positiv pressure suitable for areas* up to 50 m² 100 m²
Vacuum method suitable for areas* up to 40 m² 80 m²
Max. pessure ¹⁾Positiv pressure 200 mbar 250 mbar
Max. Druck ¹⁾ Vacuum method** 175 mbar 225 mbar
Air flow rate (free blowing) 150 m³/h 315 m³/h
Motor powe ¹⁾ 1.1 kW 2.2 kW
Input voltage / Current 230 V /  7.5 A 400 V / 14.2 A
Motor protection Thermo contact
Overheating protection High temperature bearing
Coarse particle protection Protective grid 3 mm in suction / blowing duct
Service power socket standard: 10 A service socket for dehumidifier incl. 10 A fuse –
Reserve fuse standard; one piece
Length *** 420 mm 455 mm
Width *** 430 mm 440 mm
Height *** 415 mm 560 mm
Weight 24,7 kg 45 kg
Model Standard ABS yellow, MultiQube system powder-coated, yellow
optional TTSL interface 
(ex factory, not upgradeable)		 Stainless steel housing; 
TTSL interface 
(ex factory, not upgradeable)
Scope of supply Standard incl. two connectors 38 mm
optional incl. two connectors 50 mm (instead 38 mm)
Silencer (accessories) NR19 MultiQube

positive pressure dryingIn positive pressure drying, the insulation is flooded with dry, heated air through special openings.

During the course of the flooding phase, the dry air becomes enriched with moisture from the insulation material, escapes via the edge joints or other relief openings into the room and is dried again by means of installed dehumidifying units.

Via this cycle, drying to the material-specific balanced humidity is achieved.

vacuum methodIn the vacuum method, the entire procedure is rever­sed. The moist air is extracted from the insulation by means of vacuum turbines.

In this way, a vacuum is created in the insulation which causes air from the room, dried by dehumidifiers, to flow in via the opened edge joints or other relief openings to balance the pressure again.


Link Exchange: Duong Ren - Kinh Hien Vi - Panme - Ban Map - Thuoc Cap-