TPI-708 Combustion Efficiency Flue Gas Analyzer

• Self test at power on
• Adjustable contrast
• Uses common thermal paper
• Manual paper advance

APPLICATIONS

• Thermocouples in furnace and gas appliances
•  Heat anticipator current in thermostats
•  Line voltages
•  Control Voltages
•  Flame safety control current
•  Heating element resistance
•  Compressor winding resistance
•  Contractor and relay coil resistance
•  Motor and compressor startup current
•  Motor run and start capacitors
•  Bar graph indicator of rapid fluctuations
•  Continuity of wiring
•  Measure frequency on control and line voltage
•  Record minimum and maximum of measurements
•  Measure temperature
•  Measure true RMS of distorted or non-linear signals
•  Measure line current
•  Test continuity of circuit breakers and fuses
•  Measure voltage of direct drive DC motors
•  Measure power supply voltage
•  Measure power supply current
•  Non-contact Voltage Detection

SPECIFICATIONS

• Auto/Manual

DISPLAY SPECIFICATIONS

• 4,000 count
• Analog bar graph

BASIC FEATURES

• AC volts
• DC volts
• AC amps
• DC Microamps (using the test leads)
• Resistance
• Diode test
• Audible continuity

ADDITIONAL FEATURES

• Frequency
• Capacitance
• Temperature
• Non-Contact voltage detection
• Data hold
• Relative Mode
• Min/max/peak
• Peak hold
• Sleep mode/Auto off

RANGE AND RESOLUTION

• Basic DC Accuracy: .5%
• DC Voltage (maximum): 600V
• Resolution (maximum): 0.1mV
• AC Voltage (Maximum): 600V
• Resolution (maximum): .1mV
• DC Amps (maximum): 400µA
• Resolution (maximum): .01µA
• AC Amps (maximum): 400mA
• Resolution (Maximum): .01 A
• Resistance (maximum): 40MΩ
• Resolution (maximum): 0.1Ω
• Frequency (maximum): 400MHz
• Resolution (maximum): .001KHz
• Capacitance (maximum): 40,000°F
• Resolution (maximum): .001°F
• Temperature (maximum): 1000°F

AGENCY APPROVAL

• CE IEC 1010: CAT III 600V
• cULus 3111: Pending

TPI for value and quality. Replace messy U-tubes and

expensive pressure gauges with TPI's 600 series

manometers. Isolating difficult pressure problems on

natural gas and propane systems has never been better.

Test for leaks in low-pressure gas systems with the

confidence of TPI products. Basic accuracy of ±0.5%

reading with .01 inH₂0.

SPECIFICATIONS

• Auto Range: -15 to +48 in H₂O
• Accuracy: ± 0.5% of reading +5 digits
• Resolution: .01 in H₂O
• Over Pressure: 500mBar
• Power Supply: 9V
• Relative Humidity: 0% to 80% (0° to + 40° C)
• Operating Temp: 0° to +40° C
• Storage Temp: -10° C to + 50° C
• Auto Power Off: After 40 minutes

APPLICATIONS

• Adjusting appliance regulators
• Setting delivery pressures
• Leakage "shut-in" tests
• Regulator adjustments for pressure and lock-up tests
• Test pressure switch operation on a 2-stage gas furnace in both positive and negative pressures
• Static pressures in air ducts for air balancing
• Check air filters by measuring pressure drop