Building Moisture Measurement Kit Professional

For the professional measurement of the following: Building humidity (even non-destructively, including humidity depth measurements!), wood humidity (incl. temperature compensation => increased accuracy!) and relative air humidity, dew point temperature,
Contains the following equipment: T2000 S multi-function measurement unit

Multi-function measurement unit with digital precision for humidity, temperature and air flow measurements. Possibility of connecting Trotec SDI sensors, Pt100 sensors as well as round, flat and layer-depth electrodes for material, wood and building humidity measurement.

TS 200 SDI climate sensor

For measuring air and dew point temperatures as well as relative and absolute air humidity (connectable to the T2000 S).

TS 300 SDI material humidity sensor

Capacitive sensor with alarm function for non-destructive determination of humidity levels in surface-proximity areas of up to 4 cm (connectable to the T2000 S).

TS 350 SDI building humidity sensor

Because of its microwave technology, the TS 350 SDI is suitable for the non-destructive depth humidity measurement of material thicknesses of up to 300 mm (depending on thedegree of salination).

TS 60 hand electrode

For wood and building humidity measurements using the resistance process (connectable to T500, T2000 S as well as DL 100 F and P units).

Replacement electrode tips, tin

TC 20 connector cable

TC 30 connector cable

TS 012/200 round electrodes, pair, 4 mm, insulated

Insulated electrodes (length 200 mm, diameter 4 mm) for targeted humidity measurements in hidden horizontal building levels where it is necessary to use insulated electrode rods. Faulty insulation will result in wrong measurement results. From experience, these are most commonly used to determine moisture distribution within multi-wall or ceiling structures such as floating screeds, multi walls, beamed ceilings, unventilated roofs, etc.

TS 16/200 flat electrodes, pair

Insulated electrodes for material humidity measurements using the resistance process (connectable to the T2000 S and DL 100 F).

Contact mass

TP 6 laser thermometer

The TP 6 infrared thermometer has a very wide range of applications. The unit is commonly used for a wide range of processes in industry, handicrafts, trade and hobbies. Infrared thermometers are used for contact-free measurement of surface temperatures and are thus optimally suited for assessing dew points and determining heat loss is areas such as wall surfaces. These are also suitable for localising heating loops in flooring or inspecting components in switching cabinets or for controlling temperatures in motors, turbines, bearings, etc. The TP6 has a geometric resolution of 30:1.

DL200P data logger

The DL200P is a professional data logger to monitor the climate in buildings. Due to the internal memory of 16 MB about 3,200,000 measured values can be stored. There are also each two interfaces for external electrodes and sensors.

TS 910 for DL200P - surface temperature

The TS910 external surface temperature sensor can be connected to the 3.5 mm jack port of the DL 100 E / DL 100 F / DL 100 P data loggers from Trotec. The cable is 6 m in length an the measuring range is from -20 °C to +80 °C.